Getting FMCB to work with Codebreaker 10 + esr

[Dracari]

(hope this is correct section)

i've read everyone's posts i've tried many diff versions of codebreaker 9.3 9.3 and 10 they all load. they will get to Start game but after that black screen. i dont know wth i'm doing wrong!

i have a V7 fat PS2 a cheap NAND 256 mb pendrive and offical $ony memcard setup w/ current versions of fmcb and esr.

any ideas?

[dlanor]

Originally Posted by Dracari

(hope this is correct section)

i've read everyone's posts i've tried many diff versions of codebreaker 9.3 9.3 and 10

The CodeBreaker version you're using is not what can make ESR work with it.
The important thing, without which it will never work, is that you have patched your CodeBreaker elf file with one of the patch programs that ffgriever created for that purpose.

Then you need to store a renamed copy of the ESR elf file in one of the paths where the patched CodeBreaker will load it. And my preferred location for that is "mc0:/BOOT/CB_launch.elf".

they all load. they will get to Start game but after that black screen. i dont know wth i'm doing wrong!

Most likely you are using an unpatched CodeBreaker elf, for whom that behaviour is perfectly normal, since they require an original disc in the disc tray at 'Start Game' command.

i have a V7 fat PS2 a cheap NAND 256 mb pendrive and offical $ony memcard setup w/ current versions of fmcb and esr.

Like I said above:

1: Make sure you have a properly patched copy of CodeBreaker.
2: Store a copy of the 'dvdv direct' variant of ESR as "mc0:/BOOT/CB_launch.elf".

Best regards: dlanor

[Dracari]

i just realised wtf i was doing wrong -_- i was patching my codebreaker elf file i had proper file path and file name but wasnt clicking "Use CdStop" did that now its working.. if the solution was a snake as they say it would of bit me XD