WTS: ProgSkeet Solderless Dual Nand Kit w/ Injectus JTAG Programmer - $190

[Alec]

EDIT: SOLD ON 4/25/2012

I bought these on a whim. Once I had my PS3 open and sitting in front of me, I decided I really didn't care about putting it in anymore. This is everything you need to get dual-firmware up and running, close up your PS3 and never think about it again.

It is all brand new and never used. This will allow you to install an additional set of NANDs into your Phat PS3 for dual-firmware, completely solderless. One set can have 3.55 CFW and the other can have the latest OFW.

The ProgSkeet is already programmed with the latest SL_NAND bitstream. Below is a list of everything you will get:

PROGSKEET V1.1 Crystal Blue Limited Edition x 1 ($59.95)
PROGSKEET INJECTUS JTAG ACTEL PROGRAMMER x 1 ($19.95)
PROGSKEET Adaptor PCB Kit x1 ($9.95)
PROGSKEET NAND PCB 1GBIT 128MB x 2 ($39.90)
NAND 48 Pin TSOP CLIP w\ Testing Boards x 2 ($79.90)

(Prices from XCONSOLES - Kick Ass Video Game Mods, Repair Kits and Accessories)

Subtotal retail is $209.65, but I will sell the entire kit for $190. Free shipping inside the USA, but will ship worldwide.

Send me an e-mail directly to alec2dabreen@gmail.com. I will check this thread but it will be much faster if you e-mail me instead.

http://i.imgur.com/qoxC0.jpg

[Traybourne]

I've always thought about getting a set of those NAND PCBs, but I could never find any information on how to use them. Do you need to install an extra switch somewhere on the ProgSkeet to tell it which NAND to boot from?

[Alec]

I've always thought about getting a set of those NAND PCBs, but I could never find any information on how to use them. Do you need to install an extra switch somewhere on the ProgSkeet to tell it which NAND to boot from?

I was told in the IRC channel that it depends on which set has power.