The above video goes away if you are a member and logged in, so log in now!
I've seen this forum and decited to make one too (20MHz, 18F2550, Fat PS3).
My circuit seams to start (that's what I think ) but the LED keeps blinking continuously, it goes like blink blink blink ............. blink blink blink ......... hehe :P
I have used different hex files but with no luck..
any help appreciated!!
For there who has the LED blinking but not going to dev mode ..
Originally Posted by ngoagr
1.)Kindly check your USB is wired correctly
2.)Whether you have the correct complied Hex
hope this helps
I've checked wires.. and also made the circuit from the PSGroove blogspot site, with the same results... I think the problem is my programmer, I am using Multipic Programmer (hxxp://feng3.cool.ne.jp/en/pg5v2.html) with winPic800.I can write to chip and read.. but when I verify my code it gives me an error.
Testing other chips, that I have programmed before, verification is successful.
I have to try another programmer, any good and tested sugestions?
Originally Posted by godhex
hello, I have the same problem as your and would like to know how you fixed it.
bootloader has nothing to do with psgroopic except its size.
Originally Posted by lugi
when you load the hex and it errors on load hit cancel. it will retain the booloader config.. this is why i was having issues with the LED before as my compiled hex didn't match the config of the bootloader.
Originally Posted by joeyddr
Originally Posted by TRoN
Anyone know what happens when i connect my PIC PROGRAMMER to the com port? The red led, turns on? because in mine, not happens.
Anyone knows if it's possible?
Originally Posted by allans
I know that the chip come with a bootloader so i just need to flash the PSGrooPIC. Is that?
Which program i use? PDFSUSB? WINPIC? PICkit2?
I'll need a .hex with bootloader or without?