The above video goes away if you are a member and logged in, so log in now!
I am using USB HID C18 bootloader. I can program hex with HIDBootLoader and Jailbreak is working on PS3, but in HIDBootloader I can not read from device, or reset device... I can erase device and write again, but read from device is not working. Any suggestions, what could be wrong?
This firmware should be OK. (I believe you use the USBHIDC18 bootloader).
Originally Posted by RabinoVich
It realy OK for my, i'm flash it yet. Thank you very much!
This firmware should be OK
I'm succesfully use HIDBootloader2.6b
I believe you use the USBHIDC18 bootloader
heres an upload
make by request in the irc channel in my sig.
hex for D2prog
Thanks to all but i compiled it for myself and it's working great
Originally Posted by dodex
more by request:
anoying chips –
do theses chip break ive flashed about 5 of theses 18f2550 and they getting on my nerves ive done the first digram on page one without a led and flashed with non bootloader main hex for 20mhz and works perfectly but if i flash it with bootloader Bootloader_MCHPFSUSB- BTL-pin28-RB7 20MHz custom by MP
it seems to break it or somthing because when i flash it back to erignal main hex nonbootloader it dont work in ps3 is it breaking them ?
I was talking about the guide in the OP where it specifies the components and then starts saying that we need commercial software to compile it. I was asking why that one wasn't compiled for the components used in the guide. Was there some legal reason I am unaware of? I was not begging... I don't even want it. I was just wondering why the guide was originally presented the way it was when HEXs were being so freely distributed later on in this thread. Also, I made it clear that I had just started reading the thread.
Originally Posted by lazzarusbr