just figured id post here
havent followed the thread in a while sorry guys if you were requesting hexes.
first time building a circuit like this with no breaboard
as you can see, LED on RB5, bootloader pins can be seen externally. this is probably my best design but also the most expensive as i had to butcher a usb thumb stick case for it.
despite how the picture looks, it works. there is no bridging of any kind where its not needed. the LED leg looks awful close to pin28 and it is but its not touching, rather its connected to the GND pin on the jumper. after everything was tested, i put some superglue inbetween the bad spots where it could touch tested again then filled the sumbitch up with hot glue and put the cover on quite proud of myself.