Well, i just tried this below..
"/* PSGrooPIC SRC V1.5 */
/* 1.5 Custom payload by Hermes ported to PIC
/* 1.4 Dancing Led changed to PIN_B4
/* -> Why? Because PIN_B5 is disabled when you use LVP (¬_¬')
/* -> Also, PIN_B5 should be grounded if you use LVP mode(ART2003 programmer)
/* -> Check PSGrooPIC V1.2 Schematic
/* 1.3 patches lv2 (PSGroove latest version)
/* 1.2 Led thing solved
/* 1.1 BRD emu thing solved
/* 1.0 Initial release */"
The text above is in the main.c..
So, in the original schematic of the first page i did this above and did not work (in a board that was working, without bootloader, and, previously programmed with a PICKit3)..
I have changed the led from the pin 26 to 25, and after grounded the 26 with de 19 (that is the gnd)..
After i uploaded the hex to the chip, but the led doesn't even blink/flash...
Well, thinking better now.. I guess the problem is with ME.. The procedure above is for the new board (1.2) with bootloarder, right? And i was trying to do it with the first one..
Am i wrong?