The above video goes away if you are a member and logged in, so log in now!
Article: A New & Improved ProgSkeet Coming
Article: A New & Improved ProgSkeet Coming –
nice i have heard before a while but i thought its only a rumor .
pardon my dumb question, but what are ALL the uses for this device? please someone reply my question with detail.
you can downgrade OFW from 4.26 to 3.55 in order to jailbreak and install CFW to play pirate games + you can have 2 Firmwares 1 offical firmware to play and access PSN and second FW for 3.55 CFW to play back up games
QSB is good and cheap but, in PS3 with numerous MoBo NAND/NOR points on all 15 mobo revision and version, I really cant tell much, clips are way better for installation.
Am I right in thinking this still requires soldering skills?
Can i use This to downgrade My ps3 CECH 300a slim from 4.21 to 3.55? When i brought My console it has the ofw 3.6x
The short answer is no. You can only go to 3.6x as the lowest firmware as that is the factory firmware that was installed on it and it cannot go any lower.
Originally Posted by pollicin123
if you try this with these you will end up with RLOD
CECH-25xx (JTP-001) with 3.56 from factory
CECH-25xx (JSD-001) with 3.60 from factory
CECH-25xx (JTP-001) with 3.60 from factory
CECH-30xx (KTE-001) with 3.65 from factory
CECH-40xx Will end up RLOD like all the others.
If you need to check this yourself check thew PS3DevWiki
Downgrading with Hardware flasher - PS3 Development Wiki
Hope this helps you not to brick your console.
It will still require you to solder but the qsb boards will make the job a lot easier than trying to use wire.
Originally Posted by Lampit