Rebug 4.30.1 cfw
MM Ver: 4.16.00
Can't seem to get any games to work from external.
Scans USB storage devices then shuts down.
NM: Updated MM and enabled BD Mirror only and all good now :D
You can't play PS2 PSN games on any 3.55 FW, it wasn't part of the FW till 4.21
rebug cfw link is down, whats going on?
do i need to convert my TargetID to DEX to be able to use ProDG?
also how safe is it to convert to DEX? if there is a high rate of bricking i think i'll just forget about it
is there anyway to get cfw on ofw 4.30 without a flasher yet
ok keep ignoring me because you think i am asking a stupid question, but lets get one thing clear, there is a DEX debug menu and DEX lv2, now someone tell me how a newb to Rebug is supposed to know what DEX mode means; debug menu OR lv2?
the above is especially confusing given that in my research i have seen people refer to the combination of both as DEX mode; why use ambiguous terms? why not just call it what it is?
example: with DEX lv2 you can use feature X.
next, nowhere in this release thread does it tell us that to change your TargetID means converting from CEX to DEX and on top of that nowhere does it say that to do that, that i have to be in 3.55 to retrieve my EID0, i know i can downgrade but that would have been a completely unnecessary step.
to me the whole point of Rebug is to be able to use debug/developer firmware and retail firmware at will, tbh with you given all the extra stuff required on top i'm beginning to think of Rebug as tool more than a firmware because it doesn't do half the shit you need to do before being able to fully utilise it.
i'm very ****ing pissed off by the piss poor amount of information provided here in this release article MOST ESPECIALLY BECAUSE SKUNKCYBER EVERY-****ING-WHERE I LOOK TELLS PEOPLE (AND A LOT OF TIME NOT POLITELY) TO READ THE RELEASE THREAD TO FIND OUT ALL THEY NEED TO KNOW AND HES JUST WRONG.
Dude, chill pill for you. It wasn't intentional.
Anyway, to use BDEMU and ProDG, obviously you need a DEX kernel and a DEX kernel will only run on a machine whose target id is 82...
That kind of answers itself.
So yes you need to hack your EID0 if you want to swap modes around on REX CFW.
perhaps i did go overboard there, i've had a stressful week and uncovering all these obscurities because i was basically forced to was the final straw for me, anyway apologies to the respective people i insulted and/or upset