what did I need for programming ICE chip?

[Thorsten1]

HI,

I have found three ICE chips, to forget that one I had.
Now, I have the following problem:
one chip is for V3, the other both chips are for V9/V10.

How can I programm these chips with the new code?
What did I need for this?
I have seen on one online shop (german) a ICE programmer.
Is it possible, the programmer manufactor by myself?

Thorsten

[TRoN]

Build it yourself you can.
http://www.semis.demon.co.uk/Sx/SXmain.htm

Get all the parts you must.
http://www.digikey.com/

Buy a programmer from Parallex you can.
http://www.apexvalue.com/basic_stamp...t_id_45170.htm

May the ICE be with you, always.

[Thorsten1]

HI,

thank you for the information.

But I have some questions:
the box could I made, but how does I connect the "flash" box with the ICE chip?
My ICE chip is on a green platine - how does I connect now the chip?

I am from germany, in some shops, there gives the finalchip for V3 to V12 - also one code for all version.
Now, I have seen, that in another thread a new code for the ice chip is, with automatic boot etc. - can I flash these code to my chip?

Thorsten

[S-Mario]

Yes finalchips should work with autoboot code, just connect the programmer to the four long pads on the side ( +5 , GND , osc2 , osc1 ).

[Thorsten1]

HI,

thank you, this is a good message.
The once problem, what I now have, the instruction is english, but my english is not the best.
Is it possible, to become the instruction with a german language?

Thorsten