The above video goes away if you are a member and logged in, so log in now!
After a very busy christmas and 4 tubes(48 pieces per tube) of sx28 now in slimline ps2's. (all using pic watchdog no other laserfix's)
Originally Posted by vdavide
No laser failures experienced.
over here i find we get 20% GH-035 and 80% GH-032
I have 4 GH-032-11 here in the workshop with ICE V12 and NO ps2 backups are working when I leave on 15Pf cap on the Resonator.
PS1 backup and disable are 100% working but no PS2 backup boots.
On one of the GH-032 it did boot one backup with 15pf on resonator then stopped, but after we read the post in another thread saying to remove the 15pf cap we have 100% boot rate.
So now for the GH-032 consoles we just leave 15pf off from begining and have no troubles.
ICEv112a not booting good for PAL GH-010 and PAL GH015
PS2 No BOOT
PS1 No BOOT
Dev No BOOT
We reprogram same chip/install with V110 code and no problems wotsoever.
where could I found the 15pf cap?
On the ICE Chip or on the mainboard pstwo?
I think it might be this one, its a little hard to tell on this picture.
and where could I found now the position, where the 15pf cap is?
the 15 cap is between OSC1 and OSC2 on your chip!
sorry, but what is OSC1 and OSC2?
I think, the 15pf cap is over the biggest chip, the right side.
is the 26 and 27 pin or 27 and 26...I don't remember...
now, I removed the 15pf cap betwenn OSC1 and OSC2.
But there is no function with ps2 games on dvd-r.
What could it be?
I think, the problem is, that I have sold the points F, G and I on the cdx chip and not on the vias.
Is on the vias another signal as on the the cdx chip?
I think, this pstwo is bust.
F G I A on CDX is equal to F G I A(on resistor) on vias...
this have I think, also I think the same.
But in another thread, the big thread of the ICE rev chips, there I have posted and somebody has answer me, that I must repair the vias.
The signal on the cdx ist not the same how the signal on the vias.
But why have I think, also I have sold the F, G and I contac on the cdx but the ICE rev chip have no function.
I don`t know what I could do, I would order an other chip, crystal chip, but when the signal on the vias is another as on the cdx, there is no hope, that the crystal chip works.
What do you mean?
Should I order an other chip an test this other or what could I do?