Is point s needed or not for magic3

MadMax · 02-07-2003,06:14 PM

I've intstalled an homebrew m3 on a 30004 pal without the scex and it works but if I wach a movie and I simlpy switch on stand by, when i reboot i've black screen and i need to switch the main power off to get the logo again...cause is still in dvd mode...
Can be that the cause?

MadMax · 02-07-2003,07:25 PM

solved..
It was'nt the s point but the chematic for v4 no gap on the magic3 site...
Is not possible to use the regolator near the reset cause is always at 5v on standby. U must use the other regolator.
That was used for m2 and worked because was needed 3.3 v too for the eeprom...

MadMax · 02-08-2003,01:29 PM

ok...no way...now boots but sometimes come no data screen stright

**Robot** · 02-08-2003,04:20 PM

for black screen problem , use thicker wire for +5v and GND.

If the machine boots to the browser screen straight away without any intro your wires are too long

MadMax · 02-08-2003,05:26 PM

Whatta hell...while u posting...I found the solution too using power wire shorter and thicker...
tnx robot

MadMax · 02-09-2003,12:32 PM

A solution to this matter can be a 100n capacitor between pin 2 and 4 on the sx like m2 herlier...

User Tag List

Thread: Is point s needed or not for magic3

Tweet

LinkBack

Thread Tools

Display


	Would you like to get all the new info from PSX-Scene in your email each day? Subscribe to our Daily Digest! Want to learn more about the team keeping you up to date with the latest scene news? Read about them now! Check out our Developer bios, too!