A little help

[Bizzy]

Hello guys.
Would you help me?
I want to build this chip but:
What code i must use from FINAL file?
Final,FinalR,final48 or Final48R?
What's the differences?
After the build of Fluffy2 prog, what the next steps in ICProg appl?
Plz help.If there any post asnwered already, plz give me the link.
Thanks in advance.

[Emanuel]

Do you already have a chip and want to reprogram it with FINAL ICE code or you want to build it from scratch ?

Final and FinalR are for the Ubicom SX28 microcontroller and Final48 and Final48R are for the SX48 microcontroller. You must use the version appropiate to the chip you have.

The R codes are used if you replace the transistor on the reset line of the chip with a n-channel FET transistor. The codes without R are for the normal chip connection, with a resistor on the reset line and the F point connected to a separate reset line.

[Bizzy]

Thanks for your reply.
I've made the Fluffy2 Scenix Programmer.
I have the SX28 microcontroller.What the next step?
Toput the SX28 microcontroller in programmer, but i don't know the settings and the steps i must follow in IC PROG.

[dirksch09]

OSC-in, OSC-out, GND and V5.
Use FinalR with Resistor on "Reset-Wire 33Kohm" to built in the PS2.