nor dump verification need help

[devi691]

hi ,I need help .
after 3 days of messing with progskeet.i felt that i am a step closer to downgrade my ps3
few details
PS3 model CECH-2508B
Date code 0D
upgraded to 3.70
blue progskeet 1.1
spansion s29gl128p90tfir2
neatly wired everything and got 3 identical dumps but confused if they are good dumps or not.
I am uploading my dumps please help me out.
dump1.7z

[No0bZiLLa]

that is NOT a valid dump. do not continue downgrading.

the file is only 5 MB when its compressed. it should be a little over 11MB when compressed. another thing is i cannot extract it with flow rebuilder. if its a good dump, flow rebuilder will have no problems extracting it.

i repeat this is not a good dump, please check your wiring/software ect.

[devi691]

that is NOT a valid dump. do not continue downgrading.

the file is only 5 MB when its compressed. it should be a little over 11MB when compressed. another thing is i cannot extract it with flow rebuilder. if its a good dump, flow rebuilder will have no problems extracting it.

i repeat this is not a good dump, please check your wiring/software ect.

thanks for reply ,i will check it.wiring seems ok , because i am getting partial dump, i am using winskeet40000 spansion s29gl128p90tfir2 default setting.so can you explain that exactly where i should check it

[No0bZiLLa]

try this in your winskeet settings.

COMMON TAB
Differential Flash: Yes
Verify: Yes
Abort on error: No
16 Bit: Yes
Swap Bytes: Yes
Cycle Period (ns): 125
Read Delay (µs): 50

NOR TAB
Device Size: 16MiB x 1 (16MiB total)
 Erase block regions:
Region 1: 128Kib x 128 (16MiB total)
 Options:
Buffered write (fastest, default)
Ready triggered timing (fastest, default)
Max bytes: 64 (or 32)

also which bitstream are you using?

[devi691]

try this in your winskeet settings.

COMMON TAB
Differential Flash: Yes
Verify: Yes
Abort on error: No
16 Bit: Yes
Swap Bytes: Yes
Cycle Period (ns): 125
Read Delay (µs): 50

NOR TAB
Device Size: 16MiB x 1 (16MiB total)
 Erase block regions:
Region 1: 128Kib x 128 (16MiB total)
 Options:
Buffered write (fastest, default)
Ready triggered timing (fastest, default)
Max bytes: 64 (or 32)

also which bitstream are you using?

i am not using solderless socket so i am using default preinstalled bitstream with came along with blue 1.1 version.
i used the same setting you mentioned in winskeet for earlier posted dump too.these settings were created by itself after selecting the right nor profile

[No0bZiLLa]

i am not using solderless socket so i am using default preinstalled bitstream with came along with blue 1.1 version.
i used the same setting you mentioned in winskeet for earlier posted dump too.these settings were created by itself after selecting the right nor profile

then try a different version of winskeet.
also which drivers are you using?