E3 Card + 3.41 + PSN 3.50 Spoof Issue

[Squaredwheels]

I'm currently using the 2 in one .Bin software from its site and placed the h.bin in the removable drive so it's to load Hermes 4vb psn spoof. When boot the ps3 the hardware does its job just fine. When I check the software version it the spoof doesn't seem to have worked. Any suggestions?

[Squaredwheels]

http://www.e3card-china.com/Downloads.html

Wish i found this earlier.

[Kasimodo]

Hello,
Just to say you that you can't use these files like this.
First, you must download drivers (.bin file) from Official E3 Card Reader site.
Then copy this .bin into the E3Upgrader Partition.
Afther that, you can download additionals payloads by getting *.hex* files (becarreful, *.HEX* files not *.BIN*!)
Then rename this *.HEX* file into free.hex and copy it into the E3upgrader partition.
Done

Regards,
Kasi

[Squaredwheels]

Hello,
Just to say you that you can't use these files like this.
First, you must download drivers (.bin file) from Official E3 Card Reader site.
Then copy this .bin into the E3Upgrader Partition.
Afther that, you can download additionals payloads by getting *.hex* files (becarreful, *.HEX* files not *.BIN*!)
Then rename this *.HEX* file into free.hex and copy it into the E3upgrader partition.
Done

Regards,
Kasi

Not to be a jerk or nothing but I'm well aware on how to use the product I purchased. The post was based on a spoof upgrade that wasn't available on the euro site but was available in the chinese site. I appreciate the concern and effort given to replying on my post however, thank you. =)