The above video goes away if you are a member and logged in, so log in now!
Maximus at90usb162 16mhz
Maximus at90usb162 16mhz –
hi i have been having problems getting into service mode running 3.50 and i have loaded psgrade file but when i turn on ps it just boots up i have powered off with switch at back i think the hex is not right has anyone used a maximus to degrade???? if so can you please send me the hex you used
I have got it into service mode with that board but still having problms:
Originally Posted by kezza2k
I have the Minimus AT90USB162 board. I have loaded the hex onto it, ps3 goes into service mode.
Then I turn the ps3 off and put my USB pen stick containing the 2 files on the root directory (PS3UPDAT.PUP and Lv2diag.self from file 1) the files are not in folders just both files in the root dir...into the ps3 most right port.
Power on the PS3 and the pen stick light is flashing as if its being read by the ps3, wait for 10 mins or so and then the pen sticks stops reading and the power light continuesly flashes...i have left it for half an hour and it has still been flahing so i just ended up killing the pwr.
I have tried downloading all files again and re-writing them more than once and still nothing...
The ps3 does not load after that..i turn it on power light goes green then 60 seconds later it turns off.
BUT...if i put firmware 3.50.pup (which is the firmware i am currently on) onto the usb stick and plug it in, it does exactly as before so I end up killing the power again but when i turn ps3 back on it loads normally into 3.50!
will you then tell me what the hex was that you used and i will give it a go i may be able to help but i cant even get into service mode unless you can send me the hex u used