V12/V13 problem slimfix, laserunit not moving
I had a strange problem.
The pstwo, had the garanteesticker on the bottom, but missed the additional components of the V13. Don't know if this is a V12 or V13.
I installed the Matrix Infinity, with the slimfix V3 (it was the small laser)
Standard a 1.5 KOhm resistor came with the slimfix fix, and measure with a potmeter the max and min. value and took at 2.2 kOhm.
With an open lid, it switched off after 2 seconds when turned on.
I upgraded the homebrew Matrix Infinity (they made a mistake in the factory by mixed up the homebrews with the programmed ones), by holding the reset button 3 seconds when turning on.
It could be programmed without any problems.
But when I wanted to test a ps2 game on a recordables nothing happened.
When I checked the laser, the laser produced light, hardly moved for focussing, and did not move from the outher -> innet circel.
Did not move at all any more..........strange.
Changed the slimfix for a new slimfix V3 one, same problem.
Removed the slimfix and connected the L1 and L2 to each other, everything worked.
So I installed 2x 4800 Ohm on the tracking (01D) and focus coils and the pstwo was working as expected.
Has anyone seen this before ???