HI there, i have problem with the fcking LAN connetion.
i shared the smb partion from computer, no firewall , no anti-virus.
Guest acc is on, using two methods
1. router LinkSys wtr54gl with firmware DD-WRT v24-sp2 (04/23/10) std
(SVN revision 14311) with normal internet cable
2. PS2 to PC(SMB folder) with cross-over cable -> wireshark LOGS
and with the cross-over cable its trying but i dont get it... ;[
In OPL menu 4-3-2-1 and frezeing.. ? look up the logs.
About the router(192.168.1.1), 192.168.1.2[PC] , 192.168.1.10[PS2]
Then i go to HDLoader menu [OPL 0.6] "Network Games" -> 4,3,2,1 and its hidding.
Then the PS2 is trying to connect to the PC in the control panel of dd-wrt
"Status -> LAN = Active Clients" dont shot it, but the led of the port is ON ...
Ver. SCPH-75003 PAL
Where im wrong?
Please help .....
The problem for the cross-connection is obvious and lies in the fact that the cross-connected devices are configured to use a gateway of 0.0.0.0, which is an invalid address as it does not fit within the netmasked range 10.10.0.1 through 10.10.0.255
Originally Posted by ValterVR
Instead each of these two units should be configured to use the other one's IP address as its gateway, giving you this setup:
This should give a different result, though you may have some other problems too, which were masked by this total show-stopper.
Personally I don't do it this cross-connection way, but instead have my consoles connected to the same LAN as my computers, using the same router (so all have the router IP as 'gateway'). This way all units can reach each other as well as the Internet.
That method I use should correspond to your router setup, but since you show no setup details for that beyond the IP addresses, there is no way to evaluate the validity of that configuration.
However, if you left gateway zeroed for those PC and PS2 setups as well, that is again your main problem.
For this case both PC and PS2 should use the router's IP as gateway. (Like I do it in my own LAN.)
Finally I find it hard to understand your reference to the obsolete programs HDLoader and OPL v0.6.
Why would you (or anyone) use those at this time, when OPL v0.8 is available ?
Best regards: dlanor
"Finally I find it hard to understand your reference to the obsolete programs HDLoader and OPL v0.6.
Why would you (or anyone) use those at this time, when OPL v0.8 is available ?"
becouse my flash memory has browken... and i can't upload the new one.
Here is the new logs - http://www.4d.sharecom/file/J-baq0a9/LOG2.html http://www.4shared.com/file/uL-pKYeI/LOG3.html
i back it to old,