PS2 V5 GH-015 No tray eject!

[Kwalsh24]

Ok after thinkiing I had goten my 2 ps2 systems back working again to the point that they would read cd's I now ran into another problem, my PS2 V5 will not ecject anymore. The laser is still working and the rom itself spins still but when i press eject the blue light just flases no ejecting, the gear that is used to eject the tray does not even spin at all. I think its the PS14 fuse gone but i cannot locate it so maybe there is no PS14 chip on a V5 like there is on a V4?

[wong72]

I just fixed this problem on a ps2 about 2 hours ago. It's probably not the same soloution but i'll tell you how i fixed it anyway.

All i did was open up the top of the concole and puch the tray down and ack. I had to push very hard i literally thought the CD tray was going to sanp. Good luck getting your PS2 working :thumbs:

[dudebig]

It seems as your BA5815 is dead, check PS11 if it is blown, your Ba5815 is blown too.

[bobbie]

i have the GH-015 DIAGRAM and it shows PS13 0.7A fuse but there is not one on my motherboard whitch is v5 pal

[N£TM£ÇH]

maybe the tray is just jammed..

[Zink560]

i have broken i think 5 ps2s so far, but i am fairly confident that taking out the dvd drive and looking at it carefully could show what's wrong with it. i had a ps2 with a dvd drive that wouldnt eject, i opened er up and saw the tray ontop of the rail on one side and tried to move it in and out, no go. so i pressed down really hard till i got it back into the groove and voila, problem fixed! i think this is a common enough problem that u might hav it. did u recently force the dvd tray in or out? or hav the unit fall on its side? anyways, hope my post helped