The above video goes away if you are a member and logged in, so log in now!
problem in v9 with mxl 2usa
problem in v9 with mxl 2usa –
i just finish install a matrix mxl2 on version 9 usa and every original game boot except back up any idea please help me people......
What about PS1 backups/DVD games?
Let's make first some checks:
A) Ground Wire (GND) and +3,3V wire section must be bigger than the other,
also GND must be as short as possible.
B) Wires MUST run parallel to the motherboard to avoid any interference.
C) The modchip must be separated and insulated from the motherboard with a
piece of insulation tape.
D) Check with a lens for any small drop of solder on the pins of the modchip.
all the pins should be free and there must be no short between them.
E) Check with a lens for any small drop of solder paste on the PS2
F) check at:
for a good example of correct installation of MXL2 modchip.
G) Some installers are reporting that (according the kind of wire you are
using), also the "Y" wire should be of biger section.
If the problem persist, than we must make some test:
Put the PS2 in PSX/DVD mode:
1) Try IMPORT (USA/JAP) PS1 games. Do they work?
2) Try a DVD movie using an RGB cable. Do they work? Do you see them in
If the reply to the above is YES, then wires W, R, M, N, O P, Q, T, U, V,
RST, SCEX, Y are correctly connected.
Check again the "I" "G" "A" "B" wires. Remove them completely and make them
again completely new (wire and soldering).
Also check again wire placement and make sure they do not make contact with
the metal plate which protects the motherboard.
Check GND placement and length.