help me out
well the problem with mother started off .....few
> months after i installed
> the magic 3.6 mod chip......hi,
> well i did install the mod chip perfect but i had to
> open the console once
> cause the bios clip of the magic 3.6 mod chip was
> not placed hard enough on
> the bios chip..... so after ipressed the clip hard
> and placed a piece of
> rubber on top of the clip so it will hold really
> tight on the bios chip as i
> place the mother board's metal.... it did work
> perfect for couple of months
> ....untill one day....,
> just 1 week back i opened the
> playstation2 to tune the
> lens, and as i assembled it again, and checked it
> the circles after the loading screen stopped
> moving (this is the screen
> where the u choose the browser menu or the system
> configuration menu)
> then i decided to open the the console again...to
> see what was the
> problem..but there was no problem as i could see
> with my naked eye.... so
> after i assenmbled the console again only a blank
> screen is displayed in my
> so i deceided to remove the mod chip off the mother
> as i was tried to remove the wire "S" of the magic
> 3.6 modchip off my mother
> board version 7
> i did remove the wire "S" of the magic 3.6 modchip
> from the two resistors,
> accidentally the two resistors got pulled off the
> mother board (this is
> where i soldered the two resistors at its "S"
> point). ... as i assembled the
> console and check it out every thing did work
> fine...accept for the blank
> could you please tell me the name or number of the
> two resistors, so i could
> replace it.?..
> and if theres no solution to fix my mother
> board...could please tell me,
> where i could buy a playstation2 version 7 mother
> board online?....
> please help me out .... as i really miss my
> playstation2 very
> awaiting for a immediate reply....please mail me back firstname.lastname@example.org
ok the orbs not swirling means the clock need's resetting in browser you took it to bit's for nothing :(
do you still have a black screen ? that wont be caused by the resistor and cap missing.
anyway's the resistor which came off is 100k nearest to the 157pin ic the cap below it you removed is a 4700pf cap.
thanks for your reply....
now these are the problems i face after i removed my magic3.6 modchip off my version7 motherboard....
blank screen and the blue eject light does not appear...
well the blue eject llight did not appear ....after i took my playstation 2 to a local technician........he tried checking out the motherboard only with power and the reset/eject switch connected (the dvd drive was not connected) unfortunatly after this very incident the blue light did not appear..
and blank screen may be due to the bios chip or the fuse....
how do i rectify the problems occured ... and check whether the bios chip is perfect
awaiting fro your reply
ok it's quite possible the tech has blown the ba chip and it's fuse and thats the cause of your black screen and no eject light ot the the 3.6 clip is notorious for dissconnecting the bios pins from the board leaving certain pins floating.
how do you check whether the BA5815FM chip and the bios chip is funtioning propely.
will a multi ohm meter checker help? if so please let me know,wher i should place the conducters to see whether the two chips mentined above are perfect.
well regarding the fuse, could you tell me where, is the fuse located in a version7 motherboard