The above video goes away if you are a member and logged in, so log in now!
Disc Could Not Eject, Please Help!
Disc Could Not Eject, Please Help! –
I have a version 10 and I'm trying to do the romeo mod on it, but so far no luck. I'm aware of a dead LA chip, but I just wanted to double check. Before the romeo mod, the tray opens and closes fine, just couldn't read the disc. After I did the romeo mod, the disc tray doesn't open anymore. I did lift pin #17 off the board. Any idea?
I soldered pin #17 to the red point as shown in the picture below.
I resolder the pin17 back its original position, everything work properly. So it narrows down to where I should solder pin#17 to which 5 volts.
Amazingly, just by posting here and talking to myself, i managed to figure it out. I had to solder it to a different 5 volts point.
what is romeo mod? –
hi guyz you may be thinkin what a stupid question, but can ya tell me what is the romeo mod?
changes the LA chips voltage from 12 volts down to 5 volts, which was causing the laser coils to overheat. This is for V9/V10.
Originally Posted by Jazzkyo