Follow this tutorial to the letter or risk bricking your console!
We are not Responsible if you brick you console or do anything other than Rebug is intended for.
If you do happen to brick you console you will still be able to fix it with Service Mode.
You have been warned!
USE AT YOUR OWN RISK
** You must be on Firmware 3.41 **
** YOUWILL BRICK IF YOU ARE NOT ON 3.41 **
This is a (2) part tutorial
Ok Lets Get Started
Part 1:
1. Copy the Rebug folder over to aUSB stick
2. Jailbreak your console with
PS3Break firmware V1.6
**WARNING** At this point you must flash in v1.6 firmware, not V1.71 or V1.7
3. Install Comgenie Awesome Filemanager v6
4. Install Mount Alejandro
5. Load Mount Alejandro andpressO (It will return to XMB)
6. Load Comgenie Awesome Filemanager
7. Enter the dir dev_Alejandro on the LEFT side
**WARNING** At this point you can brick your console if you are not careful!
8. PressSelect
9. Delete the directories listed below by pressing [] then Start
:::::::::::::::::::::::
data
ps1emu
ps2emu
pspemu
sys
vhs
:::::::::::::::::::::::
10. Open your USB stick on the RIGHT side and enter the Rebug directory
11. Copy over each directory by pressing O then Start
12. After all of the directories are copied to dev_Alejandro power down the console byholdingdown the ‘Power’ button
13. Install the PS3Break firmware 1.8 Rebug 3.41E Payload on your jailbreak device.
14. Jailbreak your PS3 and enjoy your new Rebugged console!. You will able to see the "debug setting" under setting at the XMB.
Part 2:
This allows to swap between Rebug's two different 'Debug Settings' menus (you can swap between debug_menu1 and debug_menu2)
1. Jailbreak your console with any Rebug 3.41E payload. You can find it at
GOGSoftware.com
3. Load Mount Alejandro and press O (It will return to XMB)
4. Load Comgenie Awesome Filemanager
5. Enter the dir dev_Alejandro/vhs/module/ on the LEFT side
6. Enter the dir dev_flash/vhs/rebug/debug_menu2 on the RIGHT side
**WARNING** At this point you can brick your console if you are not careful!
7. Press Select
8. Select sysconf_plugin.sprx and press O then start
9. Hold the PS button down and Quit Game
10. Go have a look at all the new Debug options =)
If you want to swap back to debug menu 1 follow the directions above and enter debug_menu1 instead.