iLLNESS's PSGrooPIC Hexes and Information Thread

Printable View

Show 50 post(s) from this thread on one page

10-08-2010, 01:33 AM
Debby

Thanks m8! You've made my day.
10-08-2010, 05:24 AM
Soulless

Quote:

Originally Posted by thomass

can I use MPLAB IDE (with a PICKIT 3) to upload the HEX straight away, or I can just use the program that you have mentioned?

Yes, I used mplab to upload bootload code into pic.
10-08-2010, 07:14 AM
iLLNESS

Quote:

Originally Posted by melodeath82

Found this in regards to MCHPHID Bootloader:

Source:PSGroove/PSGrooPIC diagrams, info, files, all sorts.

Hope this helps and thanx for the awesome thread.

thanks for the tip. I was pretty sure it was 1000 but couldn't test myself. I looked into compiling but I need MPLAB or whatever to shrink it down. my compiles are wayyyy too big.
10-08-2010, 02:12 PM
thomass

Quote:

Originally Posted by Soulless

Yes, I used mplab to upload bootload code into pic.

But you just upload, or, also compile with?
10-08-2010, 04:30 PM
Soulless

Quote:

Originally Posted by thomass

But you just upload, or, also compile with?

only upload bootcode hex.
10-08-2010, 04:49 PM
nand2010

Thank you for the informations,But I think U have to connect the pin 8 with 19 to ground in the first schmatic,correct me If am rong please.
10-08-2010, 05:01 PM
iLLNESS

Quote:

Originally Posted by nand2010

Thank you for the informations,But I think U have to connect the pin 8 with 19 to ground in the first schmatic,correct me If am rong please.

those pins are connected internally in the PIC. you can test yourself using a multimeter.
10-08-2010, 05:04 PM
iLLNESS

replaced the hexes for psgroopic 1.6c and 1.7a with updated hexes to reflect users who are using MetalPhreaks dual LED boards using RC0 and RC1. I did not bother updating 1.6b as 1.6c is the same except newer and works better.

Also, fixed an error with my schematic regarding RC0 as well as updated schematic to add RC1 for users who build new boards.
10-08-2010, 05:31 PM
nand2010

Thats right,Its connected internally in the PIC,thanx for the new info.
10-09-2010, 09:22 AM
itajackass

Quote:

Originally Posted by iLLNESS

For the capacitor between pins VUSB (pin14/18) and VSS (pin8/12) you can use a capacitor between 220nF to 470nF.

why MP's schematic accept 100nF too? at home, i've only 100nF.... can I use them or is it a already negative try tested?

Show 50 post(s) from this thread on one page