ICProg fails verify.
I'm trying to program a 18F2550 with my JDM programmer and ICProg 1.06B.
First of all the JDM hardware isn't detected at all in ICProg, regardless of which settings I use I'm connected via RS232 and I'm using Com4 - which is correct.
However, I can not select the 18F2550 from the menus, so I chose any of the 18F2xxxx options then load the .hex and program the chip, the little green activity LED flashes and the programming process takes about 3 minutes, but I get an error at the end of verification. :(
It it cruicial that I select 18F2550?
WinPic800 does nothing at all, it doesn't try to read or write, that's why I'm trying ICProg.
I switched over to PICPgm and it worked no problem.
Morale of the story if.......if one piece of software doesn't work, keep trying others until you find one that's happy with your setup. :)