Blackcat USB flash problem
I've not seen this problem anywhere else on these (or other) boards, so I'm going to hope someone has an understanding of what I need to do to fix this.
I received my blackcat USB earlier today, and have been attempting to flash it with various PC's, OS's, and drivers. My Blackcat USB doesn't have TCNISO, but it says EJTAG and version 1.5 or 1.6 (can't read the text well).
The short story is, its obviously not reading/writing correctly to the board.
The long story goes, I started in win 7 x64 and followed those instructions. Moved to XP virtualization mode, same thing, and now I'm on a genuine XP 32 bit machine....same thing. Within FLIP, it usually erases ok, but will hang while writing, and never make it to Verify. It gives the error at the bottom "Could not read from USB device.0x"...then, it'll go to "could not write to USB device". or "could not open USB device".
There was a great video posted over at sbhacker.net on how to flash, and it looks like I'm doing every step the same, except mine won't flash it, or verify properly. Also, another thing I've noticed is my Signature Bytes is different than the person's in the video. Mine only shows "58 00 00 00".
I'd like to try to reflash the bootloader portion, but I can't figure out how to do that.
Any suggestions? Did I just get a non-working board?
When I first got the board, the little blue light thing would light up along with RED, but no matter where I set the switches now, its only RED.