The above video goes away if you are a member and logged in, so log in now!
ps3 blu ray problem –
hi my laser was gone on my fat ps3 60gb now i replaced it and when i turn my ps3 on bluelight flashes and tries to pull in a disk and then stops and when u push a disk quarter of the way in it should try pulling in the disk but u have to put it in over half the way to get it to go in.any ideas
Did you plug in the disk sensor?
The little wire that runs from the small PBC on top of the bluray drive and connects to the daugtherboard via a small yellow connector. If it is connected reinspect the wires to make sure you didn't pull one out when you took the drive apart.
This is assuming you are using an E 60 gig system. If it was a newer model then you may have not reassembled the drive correctly and something may slightly be out of alignment.
sensor cable is plugged in fine