Minimus AVR Help?

[Magatame]

Hi, my Minimus AVR arrived today and I'm trying to get it set up, I've found loads of helpful guides but none on using Flip.. I basically opened Atmel Flip once I had the Minimus Drivers installed using a guide.. Then I click "Select target device and picked "AT90USB162" I then clicked "Select Communication Medium" then I loaded the hex files and pressed "Run" on the bottom left hand side.. All the little circles were green.. But when I put it on my PS3 and press start then eject it just comes onto the little green light and says "Unknown USB inserted" :S Any ideas?

[speighty]

On the flip software after you have pressed run and have the green light you need to press start application in the bottom right, thats why its not working.

[hairy_lee]

Hi, my Minimus AVR arrived today and I'm trying to get it set up, I've found loads of helpful guides but none on using Flip.. I basically opened Atmel Flip once I had the Minimus Drivers installed using a guide.. Then I click "Select target device and picked "AT90USB162" I then clicked "Select Communication Medium" then I loaded the hex files and pressed "Run" on the bottom left hand side.. All the little circles were green.. But when I put it on my PS3 and press start then eject it just comes onto the little green light and says "Unknown USB inserted" :S Any ideas?

I have a minimus and it took much screwing around to get it to work; in the end i flashed with the hex file for a teensy 1.0 and this worked for me. when the hack was successful the green power light came on and the red one to tell me that it was working as a teensy.

hope this helps