The above video goes away if you are a member and logged in, so log in now!
8002f0c1 error no matter what
8002f0c1 error no matter what –
I read and tried the un-brinking ps3 section except formatting on another ps3 cause I dont have anyone with another one available. My ps3 is 80gb fat and i have tried 4 different hdd even zero filling them. Also, tried keeping battery unplugged all day(I hope theres only 1? bottom of mother board in green case and cord with two slots to choose to put it in) and that has not done me anygood still get stuck at 4% on update. I dont know what firmware I have it says at update screen to update with 3.21 or above. This all started believe it or not a year ago when I was able to connect to internet for first time and did the update. Its been sitting in closet every since after spending a week trying to get it to work. After that I gave up and bought a 360 but miss my ps3 and found this forum. Also, the memory card reader is not attached but I could not find anywhere that it would cause update loop(I dont have the cable). I did the ylod fix just for the heck of it and it didnt work and i have use multiple usb disk. When in the recover mode and I choose to rebuild I get disk can not be accessed error and every drive I put in. WHen I do the update the hdd light is flashing so I figure hdd is working, but dont know if it does that for usb also. Lastly and totally random if while updating if i pull my hdd out at the 2% point it will go to 80% before the system turns off by itself???? If I pull the hdd out at 2% and put in back in at anytime ps3 will turn off 10% later. So I checked to make sure no cable is loose but hdd has no cable to connect so that weird also right?? Any suggestion will be greatly appreciated. Do I need to buy a usb jig or something?