I installed the e3 flasher and when i try to boot up the ps3 it won't give me a screen, no hdd activity and only a hard reset is possible.
The ps3devwiki says this:
Blackscreen with no hdd activity and only hard reset possible (no brick)
remove clip and try again
try getting into FSM with a faster power/eject combo
if you manually patched, check if you did not patch the byte-reversed copy
attempt flashfun downgrade
resolder SBCE -> A / cut A/B properly
restrip contacts on the backside of the E3 Flasher (they must not touch the metal casing) they have to be isolated very good .. they are very sensitive and cause a lot of errors
if the E3 flasher is not connected, also ALWAYS disconnect the clip otherwise blackscreen because of A/B Cut ..
3.55 ONLY: use the rsod/brickfix lv2diag in Service Mode (helped my system a lot .. it booted to blackscreen 8/10 times; after using lv2diag 2/10 times)
if using TBv2 please note, that instead of proper security they used loops to protect their product; try reinstalling the FW via recovery mode
also dont use custom boot logos with TBv2 !!
Reinstall a downgrader prepatched FW
if you have no success with the methods from above solder Tri/SBE and reflash a valid backup via flash fun mode (100000)
But I don't really understand this much of jailbreaking so can somebody please explain how to do these steps?
Thanks in advance