The above video goes away if you are a member and logged in, so log in now!
Maximus AVR USB 2.1 Help :(
Maximus AVR USB 2.1 Help :( –
I recently purchased the avr max usb 2.1 from vgcrepairs. When I insert it into my PC "Unrecognized device" win 7 ultimate- nothing else happens. Eventually the single red light just shuts off and nothing. Any ideas ? At my wits end, already paid to send it back once for repair. thank you
Am I really the only one with this problem ?
if i am not wrong it need a driver for win 7 to be installed in order to detect it .
Perhaps you have a link for this driver? I don't really have the money to send it back for repair yet again..
Dont know where to get the driver but it didnt work on my computer with W7 installed, did the configuration with a XP system
Okay, does anyone have any success with win 7 using MAX AVR USB 1.2? If so, what are the steps?
Have a look at Maximus AVR Tutorials
There is a set of Drivers you can download !! hopefully these will work !!
The Maximus 32kb v2.1 doesn't have the ATMEL chipset. You can't use FLIP software on that board. The board on v2.1 is PIC instead.
Originally Posted by Mango
I'm aware, I am using HIDbootloader, it doesn't work regardless..
If you are using the Maximus 1.2 with PIC chip, for it to work, do the following:
On the PC...Load up the HIDLoader...
Then hold in the small little button in the hole on the top with something like a tack...while holding it in and keeping it held, insert it into your PC...I would try a different USB Port you haven't used before...
And yes Windows 7 doesn't need additional drivers as Win7 will automatically install it.
If you did it right the HIDLoader will show that the device is connected. You should know what to do from there.
Last edited by arkinex; 11-01-2010 at 10:53 AM.