can i enter fsm on rogero cfw 4.30 v2.03

[sud88]

I recently updated from ofw 3.55 to rogero 4.30 v2.03 not knowing I had an unpaired logic board. I have replaced the bluray drive and logic board so I need to pair this new one up. However I can't toggle qa flags nor install packages without bluray drive as it halts at a black screen.

Is it safe to enter factory mode to remarry bluray on this firmware?

Thanks

[No0bZiLLa]

you will need to get back to 3.55 before you can remarry.

[bitsbubba]

try installing 3.55 from XMB, NO to FSM!

[sud88]

I was going to try that however I have heard reports of bricks. I want to follow regeros downgrade instructions, however I'm stuck on the toggle qa part I don't think I can run toggle qa without paired bluray drive. Any suggestions on how I can safely get this ps3 back to 3.55 so I can enter fsm and remarry bluray?

I have no hardware flasher or nand dumps. Thanks

[bitsbubba]

I was going to try that however I have heard reports of bricks. I want to follow regeros downgrade instructions, however I'm stuck on the toggle qa part I don't think I can run toggle qa without paired bluray drive. Any suggestions on how I can safely get this ps3 back to 3.55 so I can enter fsm and remarry bluray?

I have no hardware flasher or nand dumps. Thanks

TRY INSTALLING 3.55 CFW FROM THE XMB!!!

If not then go ahead with Rogero's downgrade method, you can not qa flag on 4.30 CFW (only 3.55) and if you have not qa flagged before installing Rogero 4.30 then it's very possible that you might need a flasher to downgrade

[sud88]

Damn not the answer I was looking for as I dont have hardware flasher. Will try to install 3.55 without toggle qa if that doesnt work im really stuck. This is my first jailbreak I really should have read more. Thanks for the help anyways.