Looking for some advice.
I'm launching ULE from MC/boot, in an effort to update HDL. I have a v12 slim with HDL 48bit installed (dev2 boot) and working fine, it's a IDE connection using HD connect (=lots of soldering). 250gb IDE WD2500BEVE drive. It was all setup via WinHiip and a HDL-48-bit-installer DVD. Modbo chip, 1.93.
Attempting to copy and paste a elf file from either MC/USB to HDD fails - "paste failed" in ULE 4.12, and a partial file copy under ULE 4.16. (no errors, file appears , but is too small - e.g. 600k HDL elf, only 300k-ish copied. Copying 350k elf, only 190k copied).
Loads of space in partitions, I've also created a new "test" partition using ULE HDD manager and same problems. I set up the ftp component, and copying files just drag&drop from windows fails for most files. But copying small files - e.g. 2k txt files - works fine and whole file is copied intact.
The fact that this fails from all sources inc ftp suggests to me ULE is failing in its write to hdd command. Obviously something has changed in this department from 4.12 to 4.16 to make it partially successful.
Completely stumped on this one - any ideas out there?
EDIT: Just tried ule 3.51 (slim version) for a test, and that just reports "paste failed" when copying any files which are not v small to hd.
It appears any version of ule I have tried is unable to copy files over a certain size to Hd.