The above video goes away if you are a member and logged in, so log in now!
Running SMS with debug output
Running SMS with debug output –
I have been working on implementing support for matroska container (mkv)
into SMS, so far I have used the MSVC version of SMS. In this version it works with both video and audio inside matroska container. So now I am trying to merge this into the latest version of SMS and try on ps2. But I would need to make some debug outputs, I have understood that this could work if you dont reset IOP, and use ps2link and InLink. ps2link and InLink
works ok for normal SMS but when I try to get debug output by removing the line "SMS_IOPReset ();" in src/main.c then it will not load SMS.
I get the following output:
Configuration Loaded successfully.
[NET] : Executing host:C:\jtag\SMS.elf ...
Setting Curent Directory to C:\jtag\.
Executing Elf host:C:\jtag\SMS.elf...
loadelf: fname host:C:\jtag\SMS.elf secname all
loadelf version 3.30
Input ELF format filename = host:C:\jtag\SMS.elf
0 00100000 000ff458 .................
start address 0x1000e0
gp address 00000000
[NET] : Sent SMS.elf at 70KB/s
open name rom0:ROMVER flag 1 data 45778
open fd = 2
I have used ps2link v1.46 and InLink v1.3.7.
Any idea how to run SMS with possiblity to get debug messages?
@jeoe: ...just replace #if 1 by #if 0 inside SMS_IOP.c (SMS_IOPReset function), since it performs some "extra tasks". Note also, that some devices may not work properly with ps2link v1.46 (at least USB doesn't work at my site) if you don't reset IOP (I think this is because iomanX module). With ps2link v1.24 they work fine, however...
Nice to hear about Matroska implementation
Furatudo aka HellHitZ