The above video goes away if you are a member and logged in, so log in now!
v12 won't spin disks –
I got a V12 PS2 from a buddy that wouldn't read any disk so I replaced the whole laser assembly with new laser and the drive motor to spin the disks but they still do not spin and it does not recognise a disk is in, the laser moves back and forth and up and down but disks do not spin.
What else should I look for?
p13 use diagram in modchip forum
Just so I have it right You are talking about the fuse diagram and ps13 fuse. right?
u got it 99% sure P13 is dead you need to replace it with same fuse
If ps13 were dead when I put a vom on ohms I would not get tone. Right? Well it does tone,
If this means the fuse is good where else should I look?
This PS2 has never been modded.
Last edited by dewman; 12-31-2005 at 03:26 AM.
this might mean the drive chip is bust cant rememba what its called but it is equivelent to the ba and la chips in the old ps2's
Well you lost me there.Where on the Motherboard is this chip and how do I test it?
Thanks for all the help
test all fuses on continuity beep=good no beep = bad . If ther is a laser fix remove it test then reinstall it. as for what jenko is saying its the RS2400FS chip it is rare for them to blow un less bad laser fix was aplyed . Also remove all conectors for laser and reinstall if not in properly will also give you same problmes.
Ok all fuses are good.No laser fix ever installed.removed all connectors and reinstalled same thing laser moves back and forth and up and down but no spin. Did find out when the laser moves in i should get a flash of light through laser, no light.
thanks for the replys