The above video goes away if you are a member and logged in, so log in now!
V12 problem –
hi my friendz ps2 V12 has problem
he claims that it bootz but after you play it for a while it freezes
any one know wat the problem and if there is any solution of fixing it
yes it is chiped (not sure if its got any fix)
Which chip is installed? Try disabling the chip and playing an original and see if it still does it. Report back with the results.
thankz for the reply
i turn off the chip and put in a original game and it still does the same fing
freeze after a few miniute of game play
i attached a pic of the board
wat i have notice is
-point W is not realli connected to the copper bit but i fink it is solder to the W track
- uses a shitty diode fix dat i dont fink is good enough
i do not know wat chip it is using
i usually use H20z and some of the point are different
is there a way to test if the laser is still in good shape
Consider to change GND and 5V wire to thicker one, thinner wire may cause unstability.
its funny where dey got dere 5V from dey bridge two resister to get vcc
anywaz can anyone tell me wat kinda mod chip it is so i can get a diagram
i would like to desolder the chip to c wat happenz
does the problem sound like the ps2 problem or the actual chip???
I have come across this exact same problem only twice since I have been installing chips. Both times it was a v12 slim and both times it was the chip at fault. I would take the chip out and get rid of the fix and see how you go.
If the ps2 works after that you know it is the chip or it's the fix at fault.Don't keep trying to play the console before you find the problem, You will fry the lens for sure. Let me know how you go.
ok herez how i went scary story lol
i desolder the chip, the guy that installed it used alot of solder on the points so i just melt the solder and pull the wire out he used so much dat a resistor moved out so i have to solder it back in
so all came off and all set to test it, pull all the stuff back together and wen i turn on the power button nothin i mean nothin came up i was shitting my pants ahhaha and on the floor i found a realli tiny resistor dat came off didnt know where it came from so i was lookin comparing with another V12 board
still no luck so i put i bak together maybe second time lucky but no
so i go wat the heck solder on the mod chip again and wala the cloud came up
as soon it came out i shut it off cause dere was no laser fix
any suggestion why i desolder it and nothin came up
actually dere no laser movement either realli bad