The above video goes away if you are a member and logged in, so log in now!
v12 laser change –
Got a v12 ps2 here with an spu 3107, just ran lens changer to change the laser to a pvr 802 as I had 5 brand new ones sat here.
Switched off, changed laser, its reading piss poor - nothing will boot, so I tried 3 seperate lasers - all new and all same problem.
I doubt all the lasers are knackered, but what do you guys reckon?
try reflash incase if corruption
did you remove the protective solder bridge ?
Of course, don't quite a few laser changes in my time, but this is first on slimline.
I thought there was no need to use lenschanger on a slimline, I was told you can do a straight swop from 3170 to 802 ???
slimline 802 aka KHM-430 and KHS-430 dont need a plash. But im sure SPU to the other 2 does need one.
On all my ps2 with pvr laser the dvd pot has ¨been around 1000-1150 ohm´s on a full working orginal v12-v14 try to lower the pot thats what I´ll should do
cause all the lasers I´ve got as "new" has have about 1500 ohm´s on dvd