ps2 v12 cant read disk after DMS4 install

**AciDBoy** · 04-09-2007,11:03 PM

jsut finished modding my first v12 with a dms4 pro se booted originals with no probs prior, and no probs with dvd-r movies, i had a neo XIV in it but it wouldent boot properly with the fix powered on so i desoldered it off and now it wont read games, i measured what i could of the resistors one lookes alittle damaged, lookks like the top metalish area was pulled off on one sife and its measureing 5.4 on the tracking and 4.8 on the focus

**solid~snake** · 04-10-2007,07:46 AM

hi, umm you need the lens fix for the v12 by not having it you risk damaging you laser, coils and the RS2004FS chip. may have already happened

have you installed toxic yet?? and does the system read any media at all( cdr's any type of dvd)???

**AciDBoy** · 04-10-2007,09:33 PM

system reads nothing, no cdr no dvd, no dvd origanal, from what i have read the neofix isent the most effective and if its burned ill replace and get a better fix, but when the fix was installed the system wouldent boot properly it booted as if the tb points where still shorted out"brigde" boot on 3 sec then power off

**solid~snake** · 04-11-2007,09:02 AM

did you remove the solder point (bridge)from the fix after you installed it or was that still left there that would cause your problem. You can also try to use j2 instead of j1 , I had to do that with a v12 and it worked perfectly. have a look around to makesure your wires aren't grounding out on the board(extra solder, solder spots, or just a wire soldered to the board. you can try to remove the power and ground from the chip and see if it boots up normally that way( be careful not to short out the board this way by letting any loose wires touch anything),or even remove the install completely. maybe you just forgot to remove the solder point from the fix(hopefully).

**AciDBoy** · 04-11-2007,01:43 PM

na i made sure to remove the solder bridge, got to try booting with out chip powered, , it wont load games while disabled, wort comes to worst, ill pull the chip and try the gamestop trick

**phang** · 05-01-2007,03:19 PM

Well this happened to me too but i just open it again come to see that the ribbin cable for the lens were not

User Tag List

Thread: ps2 v12 cant read disk after DMS4 install

Tweet

LinkBack

Thread Tools

Display


	Would you like to get all the new info from PSX-Scene in your email each day? Subscribe to our Daily Digest! Want to learn more about the team keeping you up to date with the latest scene news? Read about them now! Check out our Developer bios, too!