The above video goes away if you are a member and logged in, so log in now!
HELP Component Value...
HELP Component Value... –
I want to know a value for the Resistor and capacitor around a SX motherboard PS2 V12 point.
SX it's a point to reach from the motherboard PS2 to Matrix Infinity SX point.
Many thanks for your help
did u burn that pont off?? if its marked 104 i think its 10k and the cap is .0001uf
Just for clarification, i attatch a photo with the two values than i want to know.
Please let me know if you conform or no your information.
the brown one is a cap probl .0001uf an normal sx point is 10k risistor black shuld have 3 # on it 104 if so its 10k bust out your multi meter set it to 2000 ohm and test for your self.. as for testing the cap u have to remove it frome the board to get a acurit value If it ant broke why fix it. im buirnt 9 systems installs and no sleep and one repari job thats that did not work custormer tryed and fryed his board im going to get some ZZZ b4 i do two homebrew xbox installs. also if u spent liek $20 USD on your meeter ul probly get a value of 9.33 or sumting close to 10k U can sub with norma 1/4wat ristor and just jumper the wire to the 2 ponts on the MB. cant find a 10k get two 4.7k and jsut solder them togetr. Use the SX point of the Big IC chip i alwase install on the big IC for s and BCGHIF Points Skrew messing with Via Points for 20min+. 4 min max on the big ic for all control points including prep. ( if your still under 25 installs i wuld recomend stiking to the diagrams from the net un less u got some balls or on a ver 1-5.) Good night and good luck
Last edited by crans; 11-23-2005 at 02:07 PM.
Many thanks for your help
So your saying to solder the 10k resistor to the sx point and the brown cap .
Originally Posted by crans
yes i say go for the 10k to replace the sx point make sure the 3#'s are 104 if its any difrent numbers just look around the board to find same one and take a reading .
I have some news..... but bad news.
I weld 10K resistor and 0.0001UF, but i have a problem. I have a matrix infinity and fix.
When i put a original DVD, and start PS2, i've got a Navigation screen and my ps2 is stuck. To restart it i unplug ps2.
When i put a DVD copy, i ve got: This is not a DVD for PS2 something like that.
When i put a CD copy i've got the same thing.
When i put a cd with a firmware update, i can hear the cd turn but after 1 minute ps2 say, unable to read this CD. The switch power/reset working.
If you have an idea, please help me.
make sure none of your fuses have blown .. if not then remove matrix test make sure ther are no bits of solder on the board or shorts..