Did I screw B-G-I-H points on my ps2 v9?

**karising** · 06-06-2006,01:24 PM

I having a bad day doing soldering on my ps2 v9 on B-G-I-H points (alternative ways not on the pin of IC chip, but below the IC chip) , I think I have screwed up the ps2, cause I cant get the 4 points successfully soldered, I take too much time to solder one point, more than two seconds, I think I already melt the circuit inside. Actually what connected to this 4 points? If I stand too long to solder it, will my ps2 spoilt? Please someone please help me... poor little soul...

**karising** · 06-06-2006,10:42 PM

Anyone can enlight me? Cause I didnt know wheater my ps2 mobo spoil because of these four points. BGIH...

**jenko** · 06-07-2006,07:55 AM

picture

**JuliusPleaser** · 06-07-2006,10:19 AM

Post pictures to show us what you have done. Normally for stubborn vias if you scrap they carefully to expose the copper and use flux, it solders on just fine.

**karising** · 06-08-2006,12:09 PM

I solder back the point already, but real problem still occur... i will tell my story clearer in another thread.

User Tag List

Thread: Did I screw B-G-I-H points on my ps2 v9?

Tweet

LinkBack

Thread Tools

Display


	Would you like to get all the new info from PSX-Scene in your email each day? Subscribe to our Daily Digest! Want to learn more about the team keeping you up to date with the latest scene news? Read about them now! Check out our Developer bios, too!