The above video goes away if you are a member and logged in, so log in now!
Calling all Pro installers one more time.
Calling all Pro installers one more time. –
ok hear we go again.
Customer tryed to install dms4 on a v9. He poped off resistor 104 (DMS X point S for other mods) and bridged 4 points on the bios (yes his first install) so i riped out the chip and all the wires, cleand it up removed even more splater around the board and flux. replaced the 104smt. system boots up acts like its going to boot a game then duble chirp comes up with no disk then shows ps2 i hit X and this time triple chirp and no disk then ps2.
Also tryed DVD movie and starts to load then gives me dvd player not set up(He stated that he waches movies some times).
Ok so fist thing i test lazer coils(HD7) bolth good at 5. test all fues all are good. rescan board for briges and such but dont find any more. removed the 104 replacement same sindrome as b4. Also saw that on his dms ther are burn marks I asked him what kind of soldring iorn he used and hes no to sure but i know is not grounded and not a gun.
can any one think of any thing i am missing??
I told him b4 i took it that its going to work or not . Looks like it might be used for scrap parts.
n/m i got it fixed som how one of his stranded wires got under the bios legs tryed for 1hr to get it out with wick and briging but no luck so i just lifted the 5 bios legs wicked it out and layed them down all is good