The above video goes away if you are a member and logged in, so log in now!
Was wondering... –
I read somewhere, I dont remember where, that when you're installing a modchip you can solder just the wires to the ps2, then put it all back together and check to see if the connections are good, before actually soldering to the chip... does this work? Will the PS2 be ok with the unsoldered ends of the wires just laying on the board??
well .. it's stupid way of testing if there is any shorts.. (if there is a short , system will not boot ) .. it will tell you if the wires were solder to the wrong spot .. or any "dry" solding joint..