Ver.10 Matrix infinity problems, need some advice.
Hi, it's been a while since I've been in the scene. I just picked up a preowned ver10 ps2 from gamestop, looks brand new too. I took it home, tested it and it worked fine with regular games & dvd movies. Well I just installed the Matrix infinity which I purchased from modchip man, and it doesn't boot any backups. I tried DVD-R, CD-R backups which I've had a while that worked on previous installations, they just won't boot. The only way I could get an original game ot dvd movie to boot is to put the game in or dvd, while on standby hold the reset button till the LED is blue on eject, let go and it will then boot. Other then that I can't even get originals to boot by just puting the disc in. If I do put the disc in alone it will not let me use my controler peroid at the browser screen, and the reset/eject if I push them nothing will happen, forcing me to turn off the console from the back. I resolderd all wires, tested all points with a multimeter, there's no bridging. The Ground and 3.3 cables are a bit long though, about 1.5 inchs each since I followed the infinity diagrams, that's as close as I could get. Maybe I need an alternative 3.3 & Ground point? Here's a picture of where I placed the chip, I put electrical tape ontop of the chip and bottom as well to avoid any shorting, double side tape to hold it down.
Placement of my chip
Any help would be greatly apreciated, this is the 1.36 bios it came shipped with btw.