V9 Still No Eject after LA6508 replaced

[modarea]

Hope you can help me.

I have a V9 that does not eject. I didn't check if the motor spins
I replaced the LA6508 with an original and it still don't eject
Laser and tray has been tested in another console and working OK
Checked all fuses, all OK

Any ideas

Thanks

[9HOMERSIMPSON9]

Check the bios chip, the slightest bridge (even one that is invisable to the naked eye) will cause this problem!

Get a smal pin and scrap in between the chip legs are re-test your console and see if that helps!

Homer

[kl1k]

have you double checked all the legs on the LA - its easy for one of them to not make proper contact after replacing the chip.

[modarea]

Checked the bios, no problem, the console is going to the browser.

Checked all LA connection and all good.
Also, I changed the LA and tested out with a replacement LA with flexboard, same

Really strange, nobody did have the same problem ?
Thanks for helping

[qortizone]

Usually it's because the legs of the LA chip aren't making proper contact. Otherwise, it could be a fuse. Alternatively, something is stuck in one of the cogs that turn to open/close the tray. I had a machine this week where someone had spilt superglue on the cogs, so they were glued shut.

[kl1k]

if your 100% its not the pads or the fuses then I'm afraid its terminal. does it spin up and boot?

[modarea]

It's booting to tyhe browser, I didn't try to put a disc, concentrating on the eject tray first.
Will check with the disc spinning, worst case would be a flip cover

Thanks