The above video goes away if you are a member and logged in, so log in now!
v7 clone prob? –
ok I have done several installs and I'm loseing my mind!
I have installed 2 v7 m2 clones and I get no audio or video when I power on these are 2 new v7 machines the eject light blinks on power on and then gose out I have checked all my points and dont think I blew a fuse I need to know what wires to rip out and what could cause this?
I think this is covered in my troubleshooting guide in the FAQ. Did you go there?
Yes charlie I have read the guide in fact its like my holy grail
but no fuses are blown and I dont se any metal shards on the mobo All my points look good but could a point be bridged? and what point would cause this? I have done this many of times but never had this prob?
thanx for your input
point could be bridged either on the cd controller points (bottom) or the bios points... or you could have 2 bad chips (I've had several clones give me this problem, then I switched em out and they worked like a charm)
hope that helps a little
thanx I will try
i could be wrong but try checking the scex point i had trouble one months ago and it gave me no sound trouble
you havent by any chance put to much solder on the bios pins it might have bridged from behind the bios pins, its just a guess
useally when you got no sound no pictures its normally the bios either bridge or damaged
just a thought
old crow builder
ps3 jap, 320hhd online
ps2 pal v9 dms3 offline
ps2 pal slim dms4 offline
Australian based mod installer and repairer, any inquiries
email me firstname.lastname@example.org
Now unbricking wii consoles at a low cost