hi guys:)
been given a v4 to mod, it looked pretty old and dusty so i thought i'd check a few discs etc before i started. it wouldn't read a dvdr film and goes to browesr for around 3 - 4 secs before booting an original:wow:
now would you just give it back and say the lasers going and save yourself the hassle or would you mess around with the laser pots??
P:)
just open up the ps2 and clean the laser with compressed air
then boot a original propably everything boots up right away
if not just give the laser a little bit more juice
i have done lots of v4 and this will always do the trick
good luck
MABCOM
tried cleaning and adjusting the height of the laser and no change:(
i'll have a go at adjusting the pots later:)
cheers for the advice
P