The above video goes away if you are a member and logged in, so log in now!
V12 tries to spin up but cant
V12 tries to spin up but cant –
I have 2 V12 both with DMS4 Lite, after install and applying the fix "summones fix" so I removed the fix and tried neoii fix and I get the same reaction. it will spin then stop, spint then stop it does this about ten times then says disc cant be read. I measured coils and both are around 5.2 and 5.6 ohms. What can this BE
Oh yea and the lasers are not fried!!!
#1 check the install again, i dont think its the fix that is the issue.
#2 did you flash the dms4 lite with the toxic bios ?
That means you have dirt on the SCEX point - clean it with a qtip+acetone and it should work again
good to know
Originally Posted by summ0ne
neat, will keep this in mind.. Always clean your points and/or use some flux.
Could also be a cold solder joint on the Summ0ne fix. I found this in one machine I fixed...