v12, shows mx41.1 logo but backups boot to rsod??

any ideas on this on guys??

would fitting the h wire do anything?

P :)

Yes, try that. I had a couple of boards PAL that i needed to attach the H wire.
Matrix Team told me it dosent hurt to use H wire. but u should prob go over your dvd wires yes. i never used mx4 but had this problem on 2 v12 boards pal with 683 resistors (summ0ne fix)..

yes this has the summ0nes fix on a 683 reisitor, fitted the h wire now and it start booting backups for a couple of times now its back to rsod!!!:(

could the summ0nes fix be doing this??

i've read about doing something with the diode and the 5v point on mi's does this apply to mx4's??

P:)

it seems if i mess around with the power, turn it off fully then hit reset etc it will sometimes boot backups??

all my dvd points are good and none are touching anything else??

right now its booting backups all the time, i also removed the s wire as i didn't want it interferring with my r wire (told u i was clutching at straws;)) and now its seems to be botting backups all the time???

don't get me wrong i'm pleased but if it came back so easily could it mess up again just asd quick?

i just want to be sure its done right

P