The above video goes away if you are a member and logged in, so log in now!
V12 ps2 does not power on..Any suggestions?
V12 ps2 does not power on..Any suggestions? –
I have a ps2 v12 slim that i installed a chip on and now it doesn't power on at all (the front LED Does not even turn red on stanby)..I checked all the fuses i could see on the mobo but they are all fine (i checked for continuity on them)...any suggestions would be appreciated?
Last edited by chalosf; 07-27-2006 at 08:35 PM.
Hm, maybe your DC adapter is broken?
I removed the chip and it boots..reinstalled and now it plays backups ..i must have crossed some wires to cause to completely short out.
But now I have another problem. Its burning my lasers..I went through 2 lasers already, when i boot it, it smells funny and then the eye of the laser gets frosted and eventually stops working and is burned....I know it has to do something the fix, maybe i fried a resistor (i did the summone 2 resistor fix)
Check the resistors. One is probably failing causing the laser to burn.
what are they supposed to measuer?
Just make sure you can still measure the resistance. If you can't you probably took the solder coat off of them.
Either 303=30k or 683=68k measure both on the resistors and on the board
and make sure that they are in contact with the board if you tried to put any fix.Like the sumone or neoshit
the sumone always work, and the neo.... always burns the laser before it´s mute.If it´s a wide laser use lenschanger to make it pvr or khm cause the only fix that workes for me with wide is SumOne but after a while that laser is gone cause it´s a shitty laser from the beginning.
Thanks that helps alot..I can replace these with standard carbon resistor correct?
Originally Posted by jetcat