-
v10 p2 problem :-(
Hello , im new to this site , thought i would sign up . there is A LOT of great help on here . anyway i have modded mainy p2's but this v10 is the first . I have modded it. power up and the main comes on . i cant get the tray to open . i push it once and it blinks like 5 times and then goes solid again. and the dvd doesnt turn either. i go into the browser and nothing starts to happen , like no reading etc ? What is going on ? i would like to finish this p2. thankx again guys and i hope u can help me out. I using the the 5k6 Magic V.
Mike
-
-
ok i have taken out the chip and cleaned up all the points, put back together. and still the same problem . now i really really need help. i though maybe it was the chip but now its doesnt look that way . is a fuse blown or what ?
Mike
-
sounds like something is jammed, try taking off the dvd drive cover and see whats happening.
-
nope tray slides in in and out if i do it manualy
-
dead fuse or dead LA chip
-
it must be a short , i know it's hard job but look for splashes near the points... it always solder ball, belive me.....
-
ill check for the solder. Is the BA chip the chip beside where you connect the laser into on the board ? like jus up and to the left ? how do you check this. that chip looks good to me . also these fuses. what one would be causing this and where it it please ? thank you
-
No BA ( you have LA ).
Check for short in cd/dvd controler and look the fuses PS 11,12,13.
-
Hello what is the cd/dvd controler ? is that where the ribbon connects into from the laser ? thankx, and ill check for those fuses. also is there a diagram for the ver 10 with all the fuses mapped out ? they have one here for the 9 ? thankx. also villasg, the LA is where i said it was right ? near the connector for the laser ?
Mike
