V10 Noise and Static Problem w/ DMS3 v9

wtaag · 03-07-2004,03:12 PM

Here is what I got. V10 w/ DMS3 v9 with static and noise on boot. Even does it when its disabled. It mrecognizes backups but wont launch them. It launches and returns to teh browser. Does this on Originals too. I have tried wrapping the clk wire with a ground... i used the alt via. None of these worked. I decided to use a larger wire for the clk. This didnt work either. Below is a pic of the install. A larger res pic is in the link below.

Any comments??? Any ideas???

http://elroy.laggyservers.com/~wtaag/DSC00497.JPG

[IMG]DSC00497_Large.JPG[/IMG]

**Gladiator** · 03-07-2004,11:07 PM

Did you check shorts, loose wires, correct connections? The position of the chip looks fine for a v10. Try using a thicker wire for power as well, but mainly , use a shorter ground.

wtaag · 03-07-2004,11:29 PM

Where can I attach a ground? I dont think I have any shorts.

**Gladiator** · 03-07-2004,11:36 PM

Check this installation(its not mine), but I use it as my guide for v10. Check the ground point.

wtaag · 03-08-2004,02:46 AM

Anyone else? That ground point doesnt really exist. Did he dig a spot into the board?

**TeknoZ** · 03-08-2004,03:51 AM

Try to shorten D and E wires, maybe a thicker wire for A also, but most important with DMS3 is the GND wire.

If you don't have a GND pad nearby you can locate an area connected to GND with a multimeter and gently remove the green solder from the pcb to solder to it.

It also looks like the soldering is a little "dirty" on the dms3 pads. You can try with a different solder brand/iron o or just some flux to remove any impurities on the soldering spots.

Hope it helps.

**anja7075** · 03-10-2004,04:08 PM

I have the same problem with a v10 and i have tried everything did you find a cure? If not i will remove the chip and reinstall it

ps i would be very greatful of any help

wtaag · 03-10-2004,04:31 PM

I reinstalled mine following the guides for a v9 at www.whatevermods.com Use the via for the clk point.

**anja7075** · 03-11-2004,06:06 PM

i have reinstalled mine the noise has gone bug it starts p2 backup and origs but then screen goes black and nothing happens cd backups and ps1 backups work fine any suggestions

ps tried the link but its dead

**anja7075** · 03-14-2004,04:36 PM

hope this will help others DMS3v9 in v10 ps2 booting problem is a bug in flash 1.8 to boot ps2 games(DVDs) start the console press eject insert disk and close the tray boots 100%

User Tag List

Thread: V10 Noise and Static Problem w/ DMS3 v9

Tweet

LinkBack

Thread Tools

Display


	Would you like to get all the new info from PSX-Scene in your email each day? Subscribe to our Daily Digest! Want to learn more about the team keeping you up to date with the latest scene news? Read about them now! Check out our Developer bios, too!